Electrical products | Cables | (N)HXMH(St)-J

Close filters
 
  •  
from to
  •  
  •  
No results were found for the filter!
 Shielded cable (N)HXMH(St)-J | 3 x 1.5 mm² | 1 meter Shielded cable (N)HXMH(St)-J | 3 x 1.5 mm² | 1 meter
Shielded installation cables for the protection against low-frequency electric fields (LF) . With improved properties in the event of fire. For installations over, up, in and under finery, in dry, moistens and wet areas, as well as in the brick-work and concrete. Also suitable for use outside, if protected against sun exposure. Excluded for direct imbedding in vibration, shaking and ramming concrete. Technical data Wire count, cross section: 3 x 1.5 mm² Length: By the meter / max. 50 m on one roll possible Outer diameter: 10.2 mm Weight: 148 g/m Calorific potential: 0.43 kWh/m No PVC because of halogen-free polymer mixture (according to DIN VDE 0250 part 214) Free of plasticizers for ecological constructions Fire retardant according to EN 50266-2-4, EN 60332-1, IEC 60332-3 cat. C Nominal voltage U0/U: 300/500 V, current load according to VDE 0100 Construction according to DIN VDE 0250 part 204/209, marking according to DIN VDE 0293 Test procedures according to DIN VDE 0472, test ac voltage 50 Hz, 3500 V Bending radius accoording to DIN VDE 0298: 4 x D Operating temperature -30°C to +70°C, cabling temperature -5°C to +70°C Construction 1) Solid conductor; 2) Insulation: cross linked polyethylene; 3) Common inner covering; 4) (St)-Screen: foil with 1.13 mm wire; 5) Outer sheath: halogen free polymer compund; Information on installing Connect the ground wiring of the junction box with the ground wiring of the cable during installation! Always connect green-yellow with green-yellow , in no case connect it with the continuity wire! Protect the bare continuity wire and the foil with insulating tube . There must not be any conductive components in the junction box! Connect the shield connector = continuity wire on one side to the earth circuit connector . Do not use shielded and unshielded cables at the same time.
Content 1 lm
From 2.50EUR *

Stock status:

Add to wishlist
 Shielded cable (N)HXMH(St)-J | 3 x 2.5 mm² | 1 meter Shielded cable (N)HXMH(St)-J | 3 x 2.5 mm² | 1 meter
Shielded installation cables for the protection against low-frequency electric fields (LF) . With improved properties in the event of fire. For installations over, up, in and under finery, in dry, moistens and wet areas, as well as in the brick-work and concrete. Also suitable for use outside, if protected against sun exposure. Excluded for direct imbedding in vibration, shaking and ramming concrete. Technical data Wire count, cross section: 3 x 1.5 mm² Length: By the meter / max. 50 m on one roll possible Outer diameter: 10.2 mm Weight: 148 g/m Calorific potential: 0.43 kWh/m No PVC because of halogen-free polymer mixture (according to DIN VDE 0250 part 214) Free of plasticizers for ecological constructions Fire retardant according to EN 50266-2-4, EN 60332-1, IEC 60332-3 cat. C Nominal voltage U0/U: 300/500 V, current load according to VDE 0100 Construction according to DIN VDE 0250 part 204/209, marking according to DIN VDE 0293 Test procedures according to DIN VDE 0472, test ac voltage 50 Hz, 3500 V Bending radius accoording to DIN VDE 0298: 4 x D Operating temperature -30°C to +70°C, cabling temperature -5°C to +70°C Construction 1) Solid conductor; 2) Insulation: cross linked polyethylene; 3) Common inner covering; 4) (St)-Screen: foil with 1.13 mm wire; 5) Outer sheath: halogen free polymer compund; Information on installing Connect the ground wiring of the junction box with the ground wiring of the cable during installation! Always connect green-yellow with green-yellow , in no case connect it with the continuity wire! Protect the bare continuity wire and the foil with insulating tube . There must not be any conductive components in the junction box! Connect the shield connector = continuity wire on one side to the earth circuit connector . Do not use shielded and unshielded cables at the same time.
Content 1 lm
From 3.30EUR *

Stock status:

Add to wishlist
 Shielded cable (N)HXMH(St)-J | 5 x 1.5 mm² | 1 meter Shielded cable (N)HXMH(St)-J | 5 x 1.5 mm² | 1 meter
Shielded installation cables for the protection against low-frequency electric fields (LF) . With improved properties in the event of fire. For installations over, up, in and under finery, in dry, moistens and wet areas, as well as in the brick-work and concrete. Also suitable for use outside, if protected against sun exposure. Excluded for direct imbedding in vibration, shaking and ramming concrete. Technical data Wire count, cross section: 3 x 1.5 mm² Length: By the meter / max. 50 m on one roll possible Outer diameter: 10.2 mm Weight: 148 g/m Calorific potential: 0.43 kWh/m No PVC because of halogen-free polymer mixture (according to DIN VDE 0250 part 214) Free of plasticizers for ecological constructions Fire retardant according to EN 50266-2-4, EN 60332-1, IEC 60332-3 cat. C Nominal voltage U0/U: 300/500 V, current load according to VDE 0100 Construction according to DIN VDE 0250 part 204/209, marking according to DIN VDE 0293 Test procedures according to DIN VDE 0472, test ac voltage 50 Hz, 3500 V Bending radius accoording to DIN VDE 0298: 4 x D Operating temperature -30°C to +70°C, cabling temperature -5°C to +70°C Construction 1) Solid conductor; 2) Insulation: cross linked polyethylene; 3) Common inner covering; 4) (St)-Screen: foil with 1.13 mm wire; 5) Outer sheath: halogen free polymer compund; Information on installing Connect the ground wiring of the junction box with the ground wiring of the cable during installation! Always connect green-yellow with green-yellow , in no case connect it with the continuity wire! Protect the bare continuity wire and the foil with insulating tube . There must not be any conductive components in the junction box! Connect the shield connector = continuity wire on one side to the earth circuit connector . Do not use shielded and unshielded cables at the same time.
Content 1 lm
From 3.50EUR *

Stock status:

Add to wishlist

* All prices are gross prices which include tax, in addition shipping costs. Copyright © 2016 YSHIELD GmbH & Co. KG